Most of the time, businesses would spend lots of money to buy their forklifts. It is vital, therefore to take proper care of your machine to protect your investment into the long run. It is a great idea to know the procedures that are carried out during the care and maintenance of this piece of machine.
Amongst the best ways to tell how good the engine is running is by starting the lift truck up and listening carefully to see how it works. Like for instance, if there are any misses or knocks, the machine is defective and this should raise some issues. Furthermore listen closely for any squealing sounds which come from the belts because these sounds would provide you with a lot of information.
When doing maintenance, some of the main components you will have to pay attention to consist of the horn, safety warning devices, the overhead guard, the lights and the gauges. Any faulty components or burnt out light bulbs need to be replaced as soon as they are noticed. It is also imperative to check the wiring.
After the above parts have been checked carefully, proceed to the battery compartment in order to see if the terminals are clean. If the terminals are not clean, be sure to clean them properly. Each and every battery cell needs to be inspected in order to make certain that the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machinery and after that change the filters. The fuel filters, hydraulic filter and the transmission filter have to be frequently replaced. Before fitting them, be sure to write the date on the new filters by using a permanent marker to be able to keep track.
When the oil change has been carried out and new filters have been fitted, visually inspect the drive axle from underneath the equipment. Be sure to grease the axle if there is any grease fitting. Check the belts on the engine for any cracks or frays. If you find any, fix the problem accordingly. Then, check every other component of the machinery like the wheels. If any type of concern or fault is detected, be sure to address it immediately so as to make certain the machine is working at its safest and optimum levels.