As opposed to a sit-down unit, the stand-up lift truck unit is really different to utilize. The way at which you pick up loads and your movements are totally different. If you do not have proper training for operating a stand-up unit, you could potentially cause harm co-employees or to yourself. When using a stand-up model, you must follow the proper safety rules. There are a few basic operating standards which have to be met when operating a stand-up unit.
When starting, stand up on the forklift so as to get a feel for the controls and the steering knob. The steering is handled using the knob steering plate instead of a steering wheel. Remember that this knob moves really fast, thus, you should get used to moving it gently so as to be certain not to over steer. The horn is located on the control handle, as is the control for forwards, backwards and the movement of the forks. The floor pedal allows the equipment to move.
Turn the key to start the forklift's engine if you are ready to start. The forks should be retracted at this stage. If you are moving around the floor, the forks must be pointed slightly upwards. Do not drive with the forks in their extended position. If you are traveling forwards, move the control handle forward and step on the pedal to make the lift move forward. If you are backing up, be certain to beep your horn in order to alert people around you. Look behind you before stepping on the pedal in order to make sure the path is safe and clear. Next, while stepping on the pedal, pull the control handle towards you. Stay focused and alert and make sure that you are always operating in a safe way.
When it comes to turning corners, turn your steering knob in the direction you need to go while keeping your hand on the control handle and your foot on the power pedal. When turning right, the steering knob will move in a clockwise direction during forward travel. If you are turning left, your steering knob will go in a counter-clockwise direction.
If you have only utilized sit down models, the stand-up versions could take some getting used to. If you take some time to figure out the machinery and with some training, you could handle loads efficiently and quickly in little time.